axial rotation

英 [ˈæksiəl rəʊˈteɪʃn]

美 [ˈæksiəl roʊˈteɪʃn]

网络  绕轴自转; 自转; 轴向转动; 轴向旋转; 绕轴旋转

英英释义

noun

• rotary motion of an object around its own axis
  1. wheels in axial rotation
  Synonym:axial motionroll

双语例句

• Conclussion: Spine without instability in the anterior and middle columes fixed with TLS increases significantly in flexion, extension, lateral bending and axial rotation stability, especially in rotation.
  结论：在无明显前中柱不稳时，TLS固定后脊柱的前屈、后伸、侧弯和旋转的稳定性明显增加，尤其旋转增加较多；
• Type-selection Design and Installation Debugging of Explosion-proof Axial Flow Fan in Relative Rotation for Coal Mine
  煤矿防爆对旋流式风机的选型设计及安装调试
• Lateral bending plus axial rotation yielded the highest increase in fiber strains, followed by axial rotation plus flexion or axial rotation plus extension.
  在轴向旋转加屈曲或轴向旋转加伸展时，侧弯加轴向旋转是纤维强度增强的最大。
• In total corpectomy, the Kaneda is significantly unstable in axial rotation.
  全椎体切除使Kaneda旋转失稳；
• Conclusion: Unilateral pedicle screws fixation cannot provide sufficient stability in lateral bending and axial rotation, pedicle screws endure more stress.
  结论：单侧椎弓根螺钉固定不能很好地控制侧屈和旋转载荷，椎弓根螺钉承受较大的应力；
• The stability with wire fixation was greater and equal to in flexion and in extension, lateral bending and axial rotation respectively.
  棘突钢丝固定在前屈运动方向上可加强节段的稳定性，可恢复节段在后伸、侧弯和轴向旋转运动方向上的稳定性；
• The fact joints of L3-L4 segment increase in flexion and extension 200 positions and decrease in axial rotation.
  L3&L4节段小关节面在前屈和后伸20°时受力增大，轴向旋转时受力减小。
• [ Conclusion] ( 1) STDSP is superior to TCS in the axial loading and rotation stability and. bone construction strength retention.
  [结论]（1）静态三维钉板系统（STDSP）的轴向抗压与抗扭能力以及内固定拆除后骨强度的保留能力，均优于3根松质骨螺钉；
• When swinging drive mechanical operation, such as the rotation speed of the force to make efforts axial shaft before and backward rotation and enable higher plane.
  当摇摆传动机械运作时，等速度的旋转入力轴使出力轴向前和向后旋转，并使平面升高。
• This model was validated by comparing the average stiffness tested in flexion and extension, left lateral bending, and left axial rotation under physiological loading with the corresponding in vitro experimental data and finite element analysis data published by other scholars.
  模型的验证是通过计算在屈伸、侧弯、轴向旋转加载条件下的平均刚度值，并与以往学者实验模型及有限元模型的分析结果相比较，分析其符合程度。